Menu
Malone Mayor Gene Wright receives state recognition

Malone Mayor Gene Wright receives s…

Residents of Malone and s...

How to build a window box

How to build a window box

A window box can enhance ...

The not so permanent home permanents

The not so permanent home permanent…

During the Great Depressi...

Charlie Brunner takes over as Jackson County Fire Rescue Chief

Charlie Brunner takes over as Jacks…

After five months of sear...

Marianna Toyota rebuilding after 35 years

Marianna Toyota rebuilding after 35…

Monday morning was the en...

Charles Hagler –  NEW LOCATION SAME SERVICE

Charles Hagler – NEW LOCATION SAME…

Charles Hagler has change...

How to aerate your lawn

How to aerate your lawn

The soil in lawns can bec...

Christmas comes early to Jackson County in Dozier property

Christmas comes early to Jackson Co…

What has been in the work...

School board updated on storm damages to buildings

School board updated on storm damag…

The Board asked Director ...

Dryer vent safety tips for better performance

Dryer vent safety tips for better p…

Homeowners are often puzz...

Prev Next

How to repair a stone walkway

  • Written by  Danny Lipford
How to repair a stone walkway

Rarely are flagstone walkways completely smooth. But if stones or mortar are missing, they can become unsightly and dangerous.

To replace missing stones, you’ll need stones of similar size and thickness to what already exists. You may have to do some chipping to make the new pieces fit the voids. Do this slowly and whittle away from the edge so you don’t remove too much material.

Once the stones are dry fit, you’re ready to mix up the mortar. We’re using a pre-mixed mortar that only requires the addition of water. Remove the stones and apply some mortar each location. Then replace the stones, pressing them into the mortar.

To replace missing mortar around the existing stones, mix the mortar a little thinner so it runs into the cracks when applied to the joints. As the mortar begins to dry, you’ll want to clean it off the face of the stones using a mason brush or a sponge along with a light spray from a garden hose.

When the mortar is completely dry, clean the entire surface with a masonry or stone cleaning solution. This is necessary to prepare it for the application of a sealer.

Applying the sealer will protect the stones and the mortar so that the walkway remains safe and attractive for a long time.

Watch the video for details.

For more information, visit TodaysHomeowner.com.

Write a comment...
awesome comments!
back to top